TECHNICAL INFORMATION

Gel Temperature: Ink will gel on surface at 240° F (116° C).

Curing: Ink film will fully cure when the entire ink film reaches 320° F (160° C.) and held at this temperature for at least 15 seconds.  Because suede prints are very thick it will be necessary to slow down belt speed of dryer or increase heat to fully cure the thicker ink film.

Mesh: For direct printing a 86–160/inch (32T-64Tcm) may be used.

Stencil: Any emulsion compatible with plastisol inks.  Thicker stencil thicknesses will produce more dramatic effects.

Modification: None recommended.  If absolutely necessary after stirring add a maximum of 3-5% 501PF Curable Reducer.  Amounts higher than this could reduce height of 3D-print..

Squeegee: 70 durometer or 90/70/90 triple durometer blades are recommended.

Printing Technique: A print/flash/print technique may be necessary to produce desired results.

Clean-up: Use Enviro Series 2000 Green or Enviro Series TR Blend.

CAUTION

Always test finished prints for curing, adhesion, bleed-resistance, ink film thickness and desired look prior to beginning full production runs. Lancer Group International cannot guarantee the results or back claims that this mixed ink will test phthalate-free if any additive other than an additive manufactured by Lancer Group International is used to modify this ink. Test results by a third-party laboratory verifying all components used to produce this ink are phthalate-free and lead-free are available upon request.